Heat Pump Installation Cost in Denton, Texas
Our 2026 estimate for heat pump installation in Denton, TX is $6,200 to $15,200. That puts Denton 12% above the national average, mainly because of the larger cooling equipment local summers call for.
Denton Weather and HVAC Load
Denton logs 2,477 heating degree days and 2,646 cooling degree days in a normal year, based on the closest NOAA weather station. Neither season dominates in Denton. That balance is a big reason heat pumps and dual-fuel systems sell well in Texas. A normal year brings 38 nights at or below freezing and 95 days over 90°F. For a 2,000 sq ft house, this climate points to a heating load somewhere near 40,000 BTU/h. Treat that as a starting number. A Manual J calculation will move it up or down based on insulation and windows.
| Heating degree days / year | 2,477 |
|---|---|
| Cooling degree days / year | 2,646 |
| Nights at or below 32°F | 38 |
| Days above 90°F | 95 |
| Average low / high | 54.5°F / 76.2°F |
Denton Housing Stock
Census figures put the median build year in Denton at 1995, so a typical house here has about 31 years on it. Plenty of houses from this period still run original 1990s or early-2000s equipment, which is past its expected service life. Denton has roughly 27,000 owner-occupied homes, or 49.2% of households. Homes here have a median value of $325,700 and households a median income of $73,719. Those two numbers drive the labor adjustment in our estimate.
Denton County had 53 hail days and 31 days with damaging thunderstorm winds from 2020 through 2025, according to NOAA storm records. The largest hail reported was 5.9 inches across. Hail flattens the thin aluminum fins on condenser coils and cuts airflow. After a big storm, take a look at the outdoor unit; homeowners insurance often covers the damage. Denton County also had 4 tornado days in that period.
When It Makes Sense
- Your AC needs replacing, and you'd like cheaper heat at the same time
- Energy bills are higher than you want them to be
- The house heats with electric baseboard, oil or propane
What Moves the Price
- A ducted system or a ductless mini-split
- Backup heat, either electric strips or a gas furnace (dual-fuel)
- Size in tons, and whether the unit is cold-climate rated
- Electrical panel capacity and wiring
- Variable-speed (inverter) or single-stage compressor
For Denton we raised the national figures about 12%, based on local income, home values and climate-based equipment sizing. Get at least three written quotes; real bids can land outside this range.
What the Quote Should Cover
- Line set, drain and electrical hookups
- A load calculation and equipment selection
- The outdoor heat pump and an indoor air handler or coil
- Commissioning and warranty registration
- Thermostat setup and backup heat settings
Texas Permits, Efficiency Rules and Rebates
Texas is in the DOE's Southeast region, where new split central air conditioners need at least 14.3 SEER2 (13.8 SEER2 for systems of 45,000 BTU/h and up). Expect the contractor to pull a mechanical permit for a replacement job in Denton. If a bidder suggests skipping it, move on. Also ask for a Texas license or registration number and proof of insurance. The federal 25C tax credit ended for equipment installed after December 31, 2025, so incentives now come mostly from utilities and state programs. Check your electric and gas utility's rebate page before you pick equipment.
Before You Hire
- A dual-fuel setup keeps your gas furnace as backup for the coldest nights.
- Ask your electric utility and state energy office what heat pump rebates are open right now.
- Make sure the installer sized the system for your heating load, not only cooling.
Get Free Heat Pump Installation Quotes in Denton
Tell us where you are and up to three licensed local pros will get in touch. You don't have to hire any of them.
Heat Pump Installation Questions from Denton Homeowners
How much is heat pump installation in Denton?
Plan on $6,200 to $15,200, with most jobs near $11,200. Equipment efficiency, house size and the condition of the ducts and wiring decide where your quote falls.
When is the best time to schedule heat pump installation in Denton?
In spring or fall. Those are the slow months between heating and cooling season in Denton.
Do heat pumps work in cold weather?
Yes. Cold-climate heat pumps keep making heat well below 0°F. They lose efficiency as it gets colder, so many homes in cold regions keep backup heat.
How long does a heat pump last?
Usually 12 to 15 years. A heat pump runs year-round, so it needs maintenance twice a year rather than once.
Heat Pump Installation Near Denton
- Brownsville $5,600 to $13,800
- Killeen $5,500 to $13,500
- Amarillo $5,300 to $13,000
- Mesquite $5,900 to $14,400
- Grand Prairie $6,100 to $15,000
- Pasadena $5,900 to $14,600
- McKinney $7,300 to $18,000
- McAllen $6,000 to $14,600
Sources: U.S. Census Bureau ACS 5-year estimates 2019-2023 and 2024 population estimates; NOAA NCEI U.S. Climate Normals 1991-2020, station Denton; NOAA Storm Events Database 2020-2025, Denton County. Prices are our estimates, not contractor quotes. Updated 2026.