Heat Pump Installation Cost in Arlington, Texas

Heat Pump Installation for a home in Arlington, Texas

Our 2026 estimate for heat pump installation in Arlington, TX is $6,100 to $15,000. That puts Arlington 11% above the national average, mainly because of the larger cooling equipment local summers call for.

Low end$6,100basic equipment, easy install
Typical$11,000where most quotes land
High end$15,000high efficiency, extra work

Compare Free Quotes in Arlington

Heat Pump Installation cost in Arlington, TX: $6,100 to $15,000, typical $11,000
Arlington price range against the U.S. range, with the climate and housing numbers behind it.

Arlington Weather and HVAC Load

In a normal year, Arlington racks up 2,126 heating and 2,823 cooling degree days (NOAA 1991-2020 normals). Neither season dominates in Arlington. That balance is a big reason heat pumps and dual-fuel systems sell well in Texas. Count on roughly 36 nights below 32°F and 106 afternoons past 90°F in a typical year. For a 2,000 sq ft house, this climate points to a heating load somewhere near 40,000 BTU/h. Treat that as a starting number. A Manual J calculation will move it up or down based on insulation and windows.

Heating degree days / year2,126
Cooling degree days / year2,823
Nights at or below 32°F36
Days above 90°F106
Average low / high56.3°F / 77.4°F

Arlington Housing Stock

Census figures put the median build year in Arlington at 1985, so a typical house here has about 41 years on it. Plenty of houses from this period still run original 1990s or early-2000s equipment, which is past its expected service life. About 77,000 households here own their home, 54.8% of the occupied total. With a median household income of $73,519 and a median home value of $276,400, local labor rates come out near the national middle in our model.

NOAA storm reports for Tarrant County show 58 hail days and 38 days with damaging thunderstorm winds over the six years from 2020 to 2025. The largest hail reported was 5 inches across. Hail flattens the thin aluminum fins on condenser coils and cuts airflow. After a big storm, take a look at the outdoor unit; homeowners insurance often covers the damage. Tarrant County also had 3 tornado days in that period.

When It Makes Sense

  • Your AC needs replacing, and you'd like cheaper heat at the same time
  • The house heats with electric baseboard, oil or propane
  • Energy bills are higher than you want them to be

What Moves the Price

  • Electrical panel capacity and wiring
  • Size in tons, and whether the unit is cold-climate rated
  • Variable-speed (inverter) or single-stage compressor
  • Backup heat, either electric strips or a gas furnace (dual-fuel)
  • A ducted system or a ductless mini-split

For Arlington we raised the national figures about 11%, based on local income, home values and climate-based equipment sizing. Get at least three written quotes; real bids can land outside this range.

What the Quote Should Cover

  • Line set, drain and electrical hookups
  • A load calculation and equipment selection
  • The outdoor heat pump and an indoor air handler or coil
  • Commissioning and warranty registration
  • Thermostat setup and backup heat settings

Texas Permits, Efficiency Rules and Rebates

Texas is in the DOE's Southeast region, where new split central air conditioners need at least 14.3 SEER2 (13.8 SEER2 for systems of 45,000 BTU/h and up). Plan on a mechanical permit for most replacements in Arlington; the contractor normally pulls it. Before you sign, ask each bidder for their Texas license or registration number and proof of insurance. The federal 25C tax credit ended for equipment installed after December 31, 2025, so incentives now come mostly from utilities and state programs. Check your electric and gas utility's rebate page before you pick equipment.

Before You Hire

  • Make sure the installer sized the system for your heating load, not only cooling.
  • A dual-fuel setup keeps your gas furnace as backup for the coldest nights.
  • Ask your electric utility and state energy office what heat pump rebates are open right now.

Get Free Heat Pump Installation Quotes in Arlington

Tell us where you are and up to three licensed local pros will get in touch. You don't have to hire any of them.

Heat Pump Installation Questions from Arlington Homeowners

How much is heat pump installation in Arlington?

Plan on $6,100 to $15,000, with most jobs near $11,000. Equipment efficiency, house size and the condition of the ducts and wiring decide where your quote falls.

When is the best time to schedule heat pump installation in Arlington?

In spring or fall. Those are the slow months between heating and cooling season in Arlington.

Do heat pumps work in cold weather?

Yes. Cold-climate heat pumps keep making heat well below 0°F. They lose efficiency as it gets colder, so many homes in cold regions keep backup heat.

How long does a heat pump last?

Usually 12 to 15 years. A heat pump runs year-round, so it needs maintenance twice a year rather than once.

Heat Pump Installation Near Arlington

Sources: U.S. Census Bureau ACS 5-year estimates 2019-2023 and 2024 population estimates; NOAA NCEI U.S. Climate Normals 1991-2020, station Arlington Municipal Airport; NOAA Storm Events Database 2020-2025, Tarrant County. Prices are our estimates, not contractor quotes. Updated 2026.