Furnace Repair in Seattle, Washington

Furnace Repair for a home in Seattle, Washington

Most furnace repair bills in Seattle come in between $220 and $960, service call included. The busiest week of the year is usually the first hard freeze, when furnaces that sat idle since spring get switched on.

Low end$220simple part, normal hours
Typical$630where most quotes land
High end$960major part or after hours

Compare Free Quotes in Seattle

Furnace Repair cost in Seattle, WA: $220 to $960, typical $630
Seattle price range against the U.S. range, with the climate and housing numbers behind it.

Seattle Weather and HVAC Load

In a normal year, Seattle racks up 4,482 heating and 210 cooling degree days (NOAA 1991-2020 normals). Heating is the bigger job here, and furnaces and heat pumps in Seattle put in far more hours than the air conditioner. On average, Seattle gets 25 freezing nights and 2 days above 90°F per year. Snowfall averages about 4 inches. For a 2,000 sq ft house, this climate points to a heating load somewhere near 55,000 BTU/h. Treat that as a starting number. A Manual J calculation will move it up or down based on insulation and windows.

Heating degree days / year4,482
Cooling degree days / year210
Nights at or below 32°F25
Days above 90°F2
Average low / high45.7°F / 60.8°F

Seattle Housing Stock

Census figures put the median build year in Seattle at 1974, so a typical house here has about 52 years on it. A lot of these homes are on their second or third system by now. The ductwork is usually original, and leaky joints are common. Seattle has roughly 156,000 owner-occupied homes, or 44.2% of households. Homes here have a median value of $912,100 and households a median income of $121,984. Those two numbers drive the labor adjustment in our estimate.

NOAA's Storm Events Database shows no hail or damaging-wind days for King County from 2020 through 2025, so storm damage to outdoor units is rare here.

Symptoms Worth a Service Call

  • Cold air coming out of the vents
  • The blower won't stop running
  • The burners light, then shut off a few seconds later
  • Banging, squealing or rattling from the furnace
  • A yellow or flickering flame instead of a steady blue one

What Moves the Price

  • The furnace's age and brand, which affect parts availability
  • Whether the part is still under the manufacturer warranty
  • Night, weekend or holiday rates
  • Which part failed: a flame sensor costs far less than a control board or blower motor
  • The diagnostic or service call fee

We raised the national figures about 48% for Seattle using local income, home values and the equipment size this climate needs. Real bids can still come in outside the range, so collect three written quotes.

What the Quote Should Cover

  • A diagnostic check
  • Replacing the part that failed
  • A safety and combustion check
  • A test run through a full heating cycle

Washington Licensing and Efficiency Rules

Washington falls in the DOE's North region. New split central air conditioners must meet at least 13.4 SEER2, and heat pumps sold anywhere in the U.S. need 14.3 SEER2 and 7.5 HSPF2. A repair usually goes ahead without a permit, but the tech handling refrigerant must hold EPA 608 certification. Ask the company for its Washington license or registration number before the visit.

Before You Hire

  • Ask whether the diagnostic fee comes off the repair bill.
  • Check the filter, the thermostat batteries and the breaker first. Those three cause a surprising number of no-heat calls.
  • If the furnace is past 15, ask the tech to price both a repair and a replacement.

Get Free Furnace Repair Quotes in Seattle

Tell us where you are and up to three licensed local pros will get in touch. You don't have to hire any of them.

Furnace Repair Questions from Seattle Homeowners

What does furnace repair cost in Seattle?

Most bills land between $220 and $960, including the service call. A typical visit is about $630. Night and weekend calls cost more.

What is the most common furnace repair?

Cleaning a dirty flame sensor or replacing a cracked hot-surface ignitor. They're also two of the cheapest repairs.

Should I repair or replace my furnace?

Here's a rule many techs use: multiply the furnace's age by the repair quote. If the number is over $5,000, replacing it usually makes more sense.

Furnace Repair Near Seattle

Sources: U.S. Census Bureau ACS 5-year estimates 2019-2023 and 2024 population estimates; NOAA NCEI U.S. Climate Normals 1991-2020, station Seattle Sand Point Wsfo; NOAA Storm Events Database 2020-2025, King County. Prices are our estimates, not contractor quotes. Updated 2026.