Heat Pump Installation Cost in Texas City, Texas
Our 2026 estimate for heat pump installation in Texas City, TX is $5,900 to $14,600. That puts Texas City 8% above the national average, mainly because of lower local labor costs and the larger cooling equipment local summers call for.
Compare Free Quotes in Texas City
Texas City Weather and HVAC Load
NOAA's 1991-2020 climate normals put Texas City at 962 heating degree days and 3,307 cooling degree days per year. Cooling carries most of the load, which is why compressors and condenser fan motors wear out faster here than in northern cities. A normal year brings 3 nights at or below freezing and 56 days over 90°F.
| Heating degree days / year | 962 |
|---|---|
| Cooling degree days / year | 3,307 |
| Nights at or below 32°F | 3 |
| Days above 90°F | 56 |
| Average low / high | 65.1°F / 77.6°F |
Texas City Housing Stock
Census figures put the median build year in Texas City at 1981, so a typical house here has about 45 years on it. A lot of these homes are on their second or third system by now. The ductwork is usually original, and leaky joints are common. Texas City has roughly 12,000 owner-occupied homes, or 53.9% of households. The median home value is $190,600, and median household income is $65,447. We use both figures to adjust labor and pricing for this page.
NOAA storm reports for Galveston County show 7 hail days and 17 days with damaging thunderstorm winds over the six years from 2020 to 2025. The largest hail reported was 2.75 inches across. Storms here are more likely to cause power surges than coil damage, so a surge protector on the outdoor unit is worth the small cost. Galveston County also had 4 tornado days in that period.
When It Makes Sense
- There's no natural gas service on your street
- Your AC needs replacing, and you'd like cheaper heat at the same time
- The house heats with electric baseboard, oil or propane
What Moves the Price
- Variable-speed (inverter) or single-stage compressor
- Electrical panel capacity and wiring
- Size in tons, and whether the unit is cold-climate rated
- Backup heat, either electric strips or a gas furnace (dual-fuel)
- A ducted system or a ductless mini-split
We raised the national figures about 8% for Texas City using local income, home values and the equipment size this climate needs. Real bids can still come in outside the range, so collect three written quotes.
What the Quote Should Cover
- Thermostat setup and backup heat settings
- The outdoor heat pump and an indoor air handler or coil
- Line set, drain and electrical hookups
- Commissioning and warranty registration
- A load calculation and equipment selection
Texas Permits, Efficiency Rules and Rebates
Texas is in the DOE's Southeast region, where new split central air conditioners need at least 14.3 SEER2 (13.8 SEER2 for systems of 45,000 BTU/h and up). Equipment replacements in Texas City generally need a mechanical permit, and a reputable contractor will pull it for you. Ask for their Texas license or registration number and a certificate of insurance with the quote. The federal 25C tax credit ended for equipment installed after December 31, 2025, so incentives now come mostly from utilities and state programs. Check your electric and gas utility's rebate page before you pick equipment.
Before You Hire
- Ask your electric utility and state energy office what heat pump rebates are open right now.
- Where winters get cold, ask for a model on the NEEP cold-climate list.
- Make sure the installer sized the system for your heating load, not only cooling.
Get Free Heat Pump Installation Quotes in Texas City
Tell us where you are and up to three licensed local pros will get in touch. You don't have to hire any of them.
Heat Pump Installation Questions from Texas City Homeowners
How much is heat pump installation in Texas City?
Plan on $5,900 to $14,600, with most jobs near $10,700. Equipment efficiency, house size and the condition of the ducts and wiring decide where your quote falls.
When is the best time to schedule heat pump installation in Texas City?
Between late fall and early spring. With 56 days over 90°F, Texas City contractors are booked solid all summer, and off-season jobs are easier to schedule and negotiate.
How long does a heat pump last?
Usually 12 to 15 years. A heat pump runs year-round, so it needs maintenance twice a year rather than once.
Do heat pumps work in cold weather?
Yes. Cold-climate heat pumps keep making heat well below 0°F. They lose efficiency as it gets colder, so many homes in cold regions keep backup heat.
Heat Pump Installation Near Texas City
- League City $7,500 to $18,400
- Euless $6,300 to $15,600
- DeSoto $6,400 to $15,600
- Little Elm $7,200 to $17,800
- Burleson $6,300 to $15,600
- Wylie $6,900 to $16,900
- Port Arthur $5,300 to $13,100
- Kyle $6,600 to $16,300
Sources: U.S. Census Bureau ACS 5-year estimates 2019-2023 and 2024 population estimates; NOAA NCEI U.S. Climate Normals 1991-2020, station Galveston; NOAA Storm Events Database 2020-2025, Galveston County. Prices are our estimates, not contractor quotes. Updated 2026.